JVD koppelingen

Onderdelen op merk

 | 

JVD koppelingen


We at JVD-RC created this clutch assembly for 1/8th nitro off road and rally-game cars. After months of development and testing, the final clutch is suitable for any clutch bell with an inside diameter between 26mm and 26.8 mm and a minimum internal length of 10mm.
Delivered as a complete system which consist of a flywheel, crown, four clutch shoes, 12 springs in different tensions (green 0.9mm, gold 1.0mm, silver 1.1mm in sets of 4), the cone, a special flywheel nut and a set spacers to shim the flywheel. The clutch comes pre-mounted with 4x 1.0 mm springs and is ready to install.
Assembling and disassembling of the clutch is easy since the crown brings the springs to tension during the assembly, and loosens the springs for dis-assembly.

Advantages
– Low wear. One set of clutch allows up to 4 +/- gallons of runtime
– Easy maintenance
– Easy installation
– Save $$$
– Strong acceleration from bottom to top end
– Very reliable clutch system.




JVD90407 Conus voor JVD koppelingen
Voorraad: 1


Aantal  
Voorraad: 2


Aantal  
JVD90409 JVD koppeling 34 mm complete set
Voorraad: 0


Aantal  
JVD90409ST JVD koppeling 34 mm staal complete set
Voorraad: 0


Aantal  
JVD90410 JVD alu schoentjes + 12 veren
Voorraad: 1


Aantal  
JVD90411 JVD montage tool
Voorraad: 2


Aantal  
JVD90414 JVD carbon schoentjes + 12 veren
Voorraad: 0


Aantal  


Copyright BMS RC TUNING - All Rights Reserved. Other Content Copyright and Trade Mark throughout the site are of their respective owners, used here for review purposes only. Reprint or Reproduction of Any Material In Part or in Whole is Strictly Forbidden. BMS RC TUNING is niet verantwoordelijk voor de content van adverteerders en affiliates. Heb je vragen, opmerkingen of een klacht KLIK HIER om met ons contact op te nemen. Privacy Policy van BMS RC TUNING